Hard Wired Switch – 240V AC 1 AMP LED Dimmer
The Dimmer Switch module is hard wired to the mains power and uses wireless RF for the control communication.
To comply with Australian / NZ wiring rules a Dimmer Switch module should always be used when controlling circuits that require the control device to be installed in the roof space.
This module is only suitable for locating indoors however, it can control lights which have a suitable rating that are located outdoors or in wet areas.
The Dimmer Switch module is not suitable for speed control of ceiling fans. Conventional dimmers cannot be incorporated into a circuit using an iZone Dimmer Switch module
|Certification||AS/NZS 61058; C Tick N29007;|
|Power supply||Input: 220 – 240VAC 50Hz|
|Power consumption||Maximum 2.05 Watts switched on (no load connected)|
|Minimum 1.2 Watts switched off|
|Maximum load||1 Amp|
|Control frequency||433 MHz|
|Operating Temperature||-20oC to +50oC|
|Environment||Suitable for indoor use only|
|Requirements||An iZone Wi-Fi Bridge (COCB) is required to control an iZone Roller blind module|
|Dimensions||Height: 150mm (Excludes mounting lugs and antenna) / Width 85mm / Depth 36mm (Excludes Antenna)|